Updated the source from gpll0_out_aux to gpll0_out_main
Change-Id: Iecaefbe03c02286823d1a67ea53b180bfd8d948e
Signed-off-by: anusha <anusharao@codeaurora.org>
Updated mock_utmi_clk to 24 MHz and use appropriate clock period.
Change-Id: I080d1d7e544b97d1911dfdc597f44fcb37a7d906
Signed-off-by: Praveenkumar I <ipkumar@codeaurora.org>
This patch updates the following:
1) Removes unnecessary TIMER and THRESHOLD configurations in EDMA
2) Adds Uniphy Clock deinit and init in eth_init (during each ping
& speed change)
3) Removes preheader configurations and calculations from EDMA
as there are no preheaders in ipq9574 platform (Instead there is
a secondary descriptor)
4) Add sufficient delay after uniphy reset
5) Remove CONFIG_IPQ9574_RUMI macro from network drivers
6) Change default mac_speed to 0
7) Fix the ppe sched. and tdm configuration
8) Reduce the block size to 1280 + headers for tftp (around 1326)
for timebeing without which timeouts were observed randomly during
TFTP (Note that the MTU is 1514 bytes)
Change-Id: I4004adfb2ae0dc98d65e458c15dafcff6523744b
Signed-off-by: Selvam Sathappan Periakaruppan <speriaka@codeaurora.org>
This patch sets the function select as mdc_mdio and also
adds AQUANTIA, QCA80xx PHY ASSERT and DE-ASSERT support.
Change-Id: Ib606b51342df4e80d705271cc661f6fbe1664ed0
Signed-off-by: Selvam Sathappan Periakaruppan <speriaka@codeaurora.org
Updated the data FIFO size to work with 4K page as well.
Signed-off-by: Rajkumar Ayyasamy <arajkuma@codeaurora.org>
Change-Id: I5d94e50755b0934d1dd6c9c0d2c6759a782f52d5
This patch updates the address of the EDMA registers, removes
registers which are not used and then does the required changes
to accomodate the new EDMA Descriptor format.
This patch also does the required changes to accomodate Secondary
Descriptor which is added instead of preheaders in ipq95xx.
We have also updated the number of descriptors per ring to 128
with this patch and have also moved the configs not required for
EMU Platform to !CONFIG_IPQ9574_RUMI.
Change-Id: I6e98c457d76c66f87b74cc0eafa7088d0081f533
Signed-off-by: Selvam Sathappan Periakaruppan <speriaka@codeaurora.org>
Updated the isb function for the aarch32 config to include
ISB instruction.
Change-Id: Iea2ee7934d18d6149af4032102b1677c16b9c06c
Signed-off-by: anusha <anusharao@codeaurora.org>
Added config, dts and initial board support code for ipq9048.
Signed-off-by: anusha <anusharao@codeaurora.org>
Change-Id: Ib4d0da9aedd5c98b02c59dd83d9efa78baada335
This change make the qca_8337 switch initialization generic based on
dts irrespective of gmac controller.
Signed-off-by: Vandhiadevan Karunamoorthy <vkarunam@codeaurora.org>
Change-Id: I292992307ead2cd7bbb0763ff483dc16c266d417
This change will skip the bad blocks offsets, if any while writing
into the nand flash duirng crash when dump_to_flash enabled. This
change also verifies whether the dump data is not overwritten into
the next partition.
Signed-off-by: Karthick Shanmugham <kartshan@codeaurora.org>
Change-Id: I0eec4c772a5f5efb3c17bfd1fd3d3d9a5ff85d1d
Encryptio/Decryption
- For encryption/decryption, plain data/
encrypted date has to be written to memory
directly using mw command along with
ivadata, type and mode
- Implemented new uboot command "aes_256"
to receive the memory address where the
above data is written to
- Perfom basic sanity check against the data
received and send them to secure world through
scm calls
- This is supported only for HK/CYP, hence not
implemented for TZ running in 32bit mode
Change-Id: I589a15025cd248cf5792f13ea435c5c5b64c6066
Signed-off-by: Karthick Jeyaraman <kjeyaram@codeaurora.org>
soc_hw_version can used to prevent cross-platform
flashing of single images to prevent board
from getting bricked.
Signed-off-by: Gokul Sriram Palanisamy <gokulsri@codeaurora.org>
Change-Id: I579489498c8cbbc944b54e3050a319d1e11cb825
This changes removes NAPA support from tiny U-boot config
Signed-off-by: Vandhiadevan Karunamoorthy <vkarunam@codeaurora.org>
Change-Id: I057064d63a3ac0788275a4572242cc251a445a98
This change will enable config for serial training.
This change also fix the the logic to get most appropriate phase
out of passed phase.
This change also add support to read serial training offset from
partition table. Also patching freqency value & phase value to kernel.
Signed-off-by: Md Sadre Alam <mdalam@codeaurora.org>
Change-Id: Ibb4a5cd80f16605e8e91bdf6a0c6c484edff1735
Removed identical device-tree to reuse original dts.
Affected boards: AC02 and OAK03
OAK03 to reuse HK01 dts and AC02 to reuse AC01 dts
Signed-off-by: Gokul Sriram Palanisamy <gokulsri@codeaurora.org>
Change-Id: I5a70514370f394b15e68d5819cf8d1b52da14f3f
We had identical device-tree for different RDPs
though they are the same except for machid.
This change enables reuse of a single device-tree
across RDPs with same configurations.
Signed-off-by: Gokul Sriram Palanisamy <gokulsri@codeaurora.org>
Change-Id: If81b431e4a6afe54e427fe0a52de275fdd29df00
This Gephy is internal phy driver for ethernet
Signed-off-by: Vandhiadevan Karunamoorthy <vkarunam@codeaurora.org>
Change-Id: Ia4e744c0fbd990bdc94fe93263ac2ddbe4cecf61
This changes initialize clock and enable the block of
Gephy, Uniphy, GMAC0 & GMAC1 and also udpate Rx & Tx clock
based on speed.
Signed-off-by: Vandhiadevan Karunamoorthy <vkarunam@codeaurora.org>
Change-Id: Ia2627e17f7029c2d0d1cbb9eff26afb27aa1c057
