openwrt/target/linux
Dirk Buchwalder 71ebc54d2a
Some checks are pending
Build Kernel / Build all affected Kernels (push) Waiting to run
Build all core packages / Build all core packages for selected target (push) Waiting to run
mediatek: filogic: add support for TP-LINK BE450
This commit adds support for TP-LINK BE450.

Device specification
--------------------
SoC Type:   MediaTek MT7988D, Cortex-A73, 64-bit
RAM:        512MB
Flash:      SPI NAND GigaDevice (128 MiB)
Ethernet:   MediaTek MT7531AE (3 Ports) + 2.5GbE (internal MT7988 phy) + 10GbE (RTL8261N)

WLAN:       MT7992
WLAN 2g:    MediaTek MT7975N, b/g/n/ax/be, MIMO 4x4
WLAN 5g:    MediaTek MT7979N, a/n/ac/ax/be, MIMO 4x4
LEDs:       8 LEDs, 1 status blue, 2x WIFI blue, 2x Internet
	        blue/orange, 1 LAN blue, 1 usb blue, 1 wps blue, gpio-controlled
Button:     2 (Reset, WPS)
USB port:   Yes
Power:      12 VDC, 2 A
Connector:  Barrel
Bootloader: Main U-Boot - U-Boot 2023.10-rc4. Additionally, ubi0
            partition contain "seconduboot" (also U-Boot 2023.10-rc4)

Serial console (UART), unpopulated, located near the power connector
---------------------
heatsink
|   |
|   |
|   |     +----+-----+------+-------+               +-----------------+
|   |     | TX |  RX |  GND | +3.3V |               | power connector |
+---+     +----+-----+------+-------+               +-----------------+
                                  |
                Don't connect ----+

Disassemble: rm the 2 screws at the bottom and the one at the backside.
             un-clip the case starting at the edge above the LEDs.

Installation (UART)
-------------------
1. Place OpenWrt initramfs image on tftp server with IP 192.168.1.2
2. Attach UART, switch on the router and interrupt the boot process by
   pressing 'Ctrl-C'
3. Load and run OpenWrt initramfs image:
      tftpboot 0x50000000 openwrt-mediatek-filogic-tplink_be450-initramfs-kernel.bin && bootm 0x50000000
4. Run 'sysupgrade -n' with the sysupgrade OpenWrt image

Note: the 10GbE (RTL8261N) is only working if reverting this Realtek target specific commit:
      b77fa45d12

      The second ubi partition (ubi1) is empty and there is no known
      dual-partition mechanism, neither in u-boot nor in the stock firmware.

      NMBM is not used.

Not Working: WED, if activated, MT7992 isn't recognized any more.

Signed-off-by: Dirk Buchwalder <buchwalder@posteo.de>
Link: https://github.com/openwrt/openwrt/pull/20398
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
2025-11-08 23:39:59 +01:00
..
airoha kernel: bump 6.12 to 6.12.56 2025-11-06 22:06:54 +01:00
apm821xx apm821xx: dts: explicitly set the partition reg size for Netgear WNDR4700 2025-10-19 21:55:33 +02:00
armsr armsr: Make kernel modules depend on target 2025-07-26 01:11:21 +02:00
at91 treewide: strip trailing whitespace 2025-05-20 00:47:37 +02:00
ath79 kernel: bump 6.12 to 6.12.55 2025-10-25 01:08:12 +02:00
bcm27xx kernel: bump 6.12 to 6.12.56 2025-11-06 22:06:54 +01:00
bcm47xx bcm47xx: fix no previous prototype error 2025-11-05 08:39:07 +01:00
bcm53xx bcm53xx: modify 180-usb-xhci-add-support-for-performing-fake-doorbell.patch 2025-10-19 16:25:15 +02:00
bcm4908 bcm63xx-cfe: install into image staging dir 2025-04-13 10:44:19 +02:00
bmips bmips: fix leds on f@st3864op 2025-10-26 22:53:11 +01:00
d1 kernel: remove duplicate PREEMPT settings 2025-06-08 15:59:55 +02:00
econet kernel: bump 6.12 to 6.12.52 2025-10-22 23:35:45 +02:00
gemini gemini: Add module for VSC73xx switches 2025-09-15 23:12:56 +02:00
generic kernel: generic: mtdsplit_seil: return 0 instead of -ENODEV 2025-11-08 21:36:29 +01:00
imx kernel: bump 6.6 to 6.6.103 2025-09-01 02:05:24 +02:00
ipq40xx ipq40xx: use NVMEM-on-UBI for ASUS Lyra and introduce label mac 2025-11-01 19:31:15 +01:00
ipq806x ipq806x: drop support for kernel 6.6 2025-11-04 19:31:07 +01:00
ixp4xx ixp4xx: Add back Actiontec MI424WR A/C/D 2025-09-26 23:40:40 +02:00
kirkwood kirkwood: dts: explicitly set the partition reg size for Blackarmor NAS220 2025-10-19 21:55:33 +02:00
lantiq kernel: bump 6.12 to 6.12.55 2025-10-25 01:08:12 +02:00
layerscape layerscape: remove 6.6 kernel files 2025-11-04 23:19:28 +01:00
loongarch64 loongarch64: switch to Linux 6.12 by default 2025-09-09 00:10:31 +02:00
malta malta: drop 6.6 support 2025-07-20 23:37:37 +02:00
mediatek mediatek: filogic: add support for TP-LINK BE450 2025-11-08 23:39:59 +01:00
mpc85xx mpc85xx: p1010: kernel: add missing symbol 2025-10-16 22:23:44 +02:00
mvebu kernel: bump 6.12 to 6.12.54 2025-10-22 23:37:13 +02:00
mxs mxs: drop 6.6 support 2025-05-24 16:15:53 +02:00
octeon treewide: replace numbers with GPIO_ACTIVE 2025-10-08 14:26:24 +02:00
omap omap: enable 6.12 testing kernel 2025-08-22 20:18:16 +02:00
pistachio treewide: reset-gpio to reset-gpios 2025-10-08 14:26:24 +02:00
qoriq qoriq: dts: add missing reg property for WatchGuard Firebox M300 2025-10-19 21:55:34 +02:00
qualcommax qualcommax: ipq5018: glinet-gl-b3000: fix dts nvmem macs 2025-11-05 21:21:41 +01:00
qualcommbe qualcommbe: drop duplicated patches 2025-10-22 20:16:59 +02:00
ramips treewide: fix mistaken executable bit on dts files 2025-11-06 22:14:56 +01:00
realtek realtek: rtl930x: Add support for Plasma Cloud MCX3 Media Converter 2025-11-07 21:12:58 +01:00
rockchip kernel: bump 6.12 to 6.12.55 2025-10-25 01:08:12 +02:00
sifiveu kernel: remove duplicate PREEMPT settings 2025-06-08 15:59:55 +02:00
siflower generic: backport phylink patches for PCS/PHY caps OPs 2025-10-22 12:29:41 +02:00
starfive kernel: bump 6.12 to 6.12.56 2025-11-06 22:06:54 +01:00
stm32 stm32: drop kernel 6.6 support 2025-10-22 14:56:15 +02:00
sunxi sunxi: cortexa53: refresh kernel config 2025-10-20 00:48:11 +02:00
tegra tegra: add 6.12 as testing kernel 2025-07-13 00:49:37 +02:00
uml kernel: bump 6.12 to 6.12.33 2025-06-12 12:42:15 +02:00
x86 x86/64: enable 8250_DW 2025-10-10 10:32:20 +02:00
zynq zynq: disable unused Vitesse PHY 2025-09-08 14:21:50 +02:00
Makefile linux: fix missing default packages in profiles.json 2024-11-17 19:29:06 +01:00