Fil Dunsky 658e4adca4 mediatek: filogic: add support for Bazis AX3000WM ... - SoC: MediaTek MT7981B - CPU: 2x 1.3 GHz Cortex-A53 - Flash: 128 MiB SPI NAND (Winbond W25N01GV) - RAM: 256 MiB (Nanya NT5CC128M16JR-EK) - WLAN: 2.4 GHz, 5 GHz (MediaTek MT7976CN, 802.11ax) - Ethernet: 1x 10/100/1000/2500 Mbps MaxLinear GPY211C WAN, 1x10/100/1000 Mbps MT7981 LAN - USB 3.0 port - 2x buttons: Reset, Mesh - 3x LEDs on top panel (red, green, blue) - 3x PHY port LEDs (1 amber, 2 green) - Board version: WD830M V2.0 - Power: 5 VDC, 3 A UART: internal test points, 3V3 115200 8N1 (RX, TX, GND) Interface MAC Algorithm LAN (label) 1c:bf:ce:xx:xx:x1 0x4 WAN 1c:bf:ce:xx:xx:x2 0xa WLAN 2.4G 1c:bf:ce:xx:xx:x3 0x2a WLAN 5G 1c:bf:ce:xx:xx:x4 0x24 At the moment installation is possible via UART only since SSH root is password protected. Set a static ip on the ethernet interface of your PC: (ip address: 192.168.1.2, subnet mask:255.255.255.0). Boot into initramfs via TFTP: ``` setenv serverip 192.168.1.2 tftpboot 0x46000000 openwrt-mediatek-filogic-bazis_ax3000wm-initramfs-recovery.itb bootm 0x46000000 ``` Install kmod-mtd-rw and activate it: ``` apk update && apk add kmod-mtd-rw insmod mtd-rw i_want_a_brick=1 ``` Upload to the router and write OpenWrt BL2 and FIP bootloader: ``` mtd write openwrt-mediatek-filogic-bazis_ax3000wm-preloader.bin BL2 mtd write openwrt-mediatek-filogic-bazis_ax3000wm-bl31-uboot.fip FIP ``` Prepare ubi partition: ``` ubidetach -p /dev/mtd4 ubiformat /dev/mtd4 -y ubiattach -p /dev/mtd4 ``` Upgrade via luci web interface with sysupgrade file or by issuing a command: ``` sysupgrade -n openwrt-mediatek-filogic-bazis_ax3000wm-squashfs-sysupgrade.itb ``` Signed-off-by: Fil Dunsky <filipp.dunsky@gmail.com> Link: https://github.com/openwrt/openwrt/pull/21813 Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>		2026-02-07 22:25:47 +01:00
..
etc	mediatek: add support for BananaPi BPi-R4 Lite	2025-11-05 14:19:40 +00:00
lib/preinit	mediatek: filogic: add support for Bazis AX3000WM	2026-02-07 22:25:47 +01:00