mirror of
https://git.codelinaro.org/clo/qsdk/oss/boot/u-boot-2016.git
synced 2026-02-03 12:37:46 +01:00
fb384c4720
The functions to detect the state of the ready / busy signal is already available but only used in the SPL case. Lets use it always, also for the main U-Boot. As all boards should have this HW connection. Testing on Siemens Draco (am335x) showed a small perfomance gain by using this ready pin to detect the NAND chip state. Here the values tested on Draco with Hynix 4GBit NAND: Without NAND ready pin: U-Boot# time nand read 80400000 0 400000 NAND read: device 0 offset 0x0, size 0x400000 4194304 bytes read: OK time: 2.947 seconds, 2947 ticks With NAND ready pin: U-Boot# time nand read 80400000 0 400000 NAND read: device 0 offset 0x0, size 0x400000 4194304 bytes read: OK time: 2.795 seconds, 2795 ticks So an increase of approx. 5%. Signed-off-by: Stefan Roese <sr@denx.de> Cc: Tom Rini <trini@ti.com> Cc: Scott Wood <scottwood@freescale.com> Cc: Roger Meier <r.meier@siemens.com> Cc: Samuel Egli <samuel.egli@siemens.com> |
||
|---|---|---|
| .. | ||
| nand | ||
| onenand | ||
| spi | ||
| ubi | ||
| at45.c | ||
| cfi_flash.c | ||
| cfi_mtd.c | ||
| dataflash.c | ||
| ftsmc020.c | ||
| jedec_flash.c | ||
| Kconfig | ||
| Makefile | ||
| mtdconcat.c | ||
| mtdcore.c | ||
| mtdcore.h | ||
| mtdpart.c | ||
| mw_eeprom.c | ||
| st_smi.c | ||