mirror of
https://git.codelinaro.org/clo/qsdk/oss/boot/u-boot-2016.git
synced 2026-03-14 21:10:27 +01:00
b596df4567
icorem6 has sd on usdhci1 which is devno 0 so return proper devno from board_mmc_get_env_dev for icorem6 and icorem_6rqs Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> |
||
|---|---|---|
| .. | ||
| imx6q.c | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
Hsow to use U-Boot on Engicam i.CoreM6 (RQS) Solo/DualLite/Quad/Dual Starter Kit: -------------------------------------------------------------------------------- $ make mrproper - Configure U-Boot for Engicam i.CoreM6 Quad/Duali/Solo/DualLite: $ make imx6qdl_icore_mmc_defconfig - Configure U-Boot for Engicam i.CoreM6 RQS Quad/Duali/Solo/DualLite: $ make imx6qdl_icore_rqs_defconfig - Build U-Boot $ make This will generate the SPL image called SPL and the u-boot-dtb.img. - Flash the SPL image into the micro SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot-dtb.img image into the micro SD card: sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Jumper settings: MMC Boot: JM3 Closed - Connect the Serial cable between the Starter Kit and the PC for the console. (J28 is the Linux Serial console connector) - Insert the micro SD card in the board, power it up and U-Boot messages should come up.