Hannes Schmelzer db40c1aa1c drivers/net/phy: add fixed-phy / fixed-link support ... This patch adds support for having a "fixed-link" to some other MAC (like some embedded switch-device). For this purpose we introduce a new phy-driver, called "Fixed PHY". Fixed PHY works only with CONFIG_DM_ETH enabled, since the fixed-link is described with a subnode below ethernet interface. Most ethernet drivers (unfortunately not all are following same scheme for searching/attaching phys) are calling "phy_connect(...)" for getting a phy-device. At this point we link in, we search here for a subnode called "fixed- link", once found we start phy_device_create(...) with the special phy- id PHY_FIXED_ID (0xa5a55a5a). During init the "Fixed PHY" driver has registered with this id and now gets probed, during probe we get all the details about fixed-link out of dts, later on the phy reports this values. Signed-off-by: Hannes Schmelzer <hannes.schmelzer@br-automation.com> Signed-off-by: Hannes Schmelzer <oe5hpm@oevsv.at> Acked-by: Joe Hershberger <joe.hershberger@ni.com> Reviewed-by: Christian Gmeiner <christian.gmeiner@gmail.com>		2017-03-26 09:58:26 -05:00
..
aquantia.c
atheros.c
broadcom.c
cortina.c
davicom.c
et1011c.c
fixed.c	drivers/net/phy: add fixed-phy / fixed-link support	2017-03-26 09:58:26 -05:00
generic_10g.c
Kconfig	drivers/net/phy: add fixed-phy / fixed-link support	2017-03-26 09:58:26 -05:00
lxt.c
Makefile	drivers/net/phy: add fixed-phy / fixed-link support	2017-03-26 09:58:26 -05:00
marvell.c
micrel.c
miiphybb.c
mscc.c
mv88e61xx.c
mv88e6352.c
natsemi.c
phy.c	drivers/net/phy: add fixed-phy / fixed-link support	2017-03-26 09:58:26 -05:00
realtek.c
smsc.c
teranetics.c
ti.c
vitesse.c
xilinx_phy.c