mirror of
https://git.codelinaro.org/clo/qsdk/oss/boot/u-boot-2016.git
synced 2026-02-16 04:49:11 +01:00
6e1899e633
As per following Sections in ONFI Spec, GET_FEATURES and SET_FEATURES also need
byte-addressing on 16-bit devices.
*Section: Target Initialization"
"The Read ID and Read Parameter Page commands only use the lower 8-bits of the
data bus. The host shall not issue commands that use a word data width on x16
devices until the host determines the device supports a 16-bit data bus width
in the parameter page."
*Section: Bus Width Requirements*
"When the host supports a 16-bit bus width, only data is transferred at the
16-bit width. All address and command line transfers shall use only the lower
8-bits of the data bus. During command transfers, the host may place any value
on the upper 8-bits of the data bus. During address transfers, the host shall
set the upper 8-bits of the data bus to 00h."
So porting following commit from linux kernel
commit e34fcb07a6d57411de6e15a47724fbe92c5caa42
Author: David Mosberger <davidm@egauge.net> (preserving authorship)
mtd: nand: fix GET/SET_FEATURES address on 16-bit devices
Signed-off-by: Pekon Gupta <pekon@ti.com>
|
||
|---|---|---|
| .. | ||
| bbm.h | ||
| concat.h | ||
| doc2000.h | ||
| docg4.h | ||
| fsl_upm.h | ||
| fsmc_nand.h | ||
| mtd.h | ||
| nand.h | ||
| nand_bch.h | ||
| nand_ecc.h | ||
| ndfc.h | ||
| omap_elm.h | ||
| omap_gpmc.h | ||
| onenand.h | ||
| onenand_regs.h | ||
| partitions.h | ||
| samsung_onenand.h | ||
| st_smi.h | ||
| ubi.h | ||