mirror of
https://git.codelinaro.org/clo/qsdk/oss/boot/u-boot-2016.git
synced 2026-03-14 21:10:27 +01:00
69cc97f8db
As per OMAP3530 TRM referenced below [1] For large-page NAND, ROM code expects following ecc-layout for HAM1 ecc-scheme - OOB[1] (offset of 1 *byte* from start of OOB) for x8 NAND device - OOB[2] (offset of 1 *word* from start of OOB) for x16 NAND device Thus ecc-layout expected by ROM code for HAM1 ecc-scheme is: *for x8 NAND Device* +--------+---------+---------+---------+---------+---------+---------+ | xxxx | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | ... +--------+---------+---------+---------+---------+---------+---------+ *for x16 NAND Device* +--------+--------+---------+---------+---------+---------+---------+---------+ | xxxxx | xxxxx | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | +--------+--------+---------+---------+---------+---------+---------+---------+ This patch fixes ecc-layout *only* for HAM1, as required by ROM-code For other ecc-schemes like (BCH8) ecc-layout is same for x8 or x16 devices. [1] OMAP3530: http://www.ti.com/product/omap3530 TRM: http://www.ti.com/litv/pdf/spruf98x Chapter-25: Initialization Sub-topic: Memory Booting Section: 25.4.7.4 NAND Figure 25-19. ECC Locations in NAND Spare Areas Reported-by: Stefan Roese <sr@denx.de> Signed-off-by: Pekon Gupta <pekon@ti.com> Tested-by: Stefan Roese <sr@denx.de> |
||
|---|---|---|
| .. | ||
| bios_emulator | ||
| block | ||
| bootcount | ||
| crypto | ||
| ddr/fsl | ||
| dfu | ||
| dma | ||
| fpga | ||
| gpio | ||
| hwmon | ||
| i2c | ||
| input | ||
| misc | ||
| mmc | ||
| mtd | ||
| net | ||
| pci | ||
| pcmcia | ||
| power | ||
| qe | ||
| rtc | ||
| serial | ||
| sound | ||
| spi | ||
| tpm | ||
| twserial | ||
| usb | ||
| video | ||
| watchdog | ||
| Makefile | ||