Bo Shen c83cb5f665 Net: macb: reset GBE bit when fallback checking ... If the GBE bit is set, when do next time autonegotiation, if the result is not 1000Mbps, it will fallback to 100Mbps checking. So, we need to clear the GBE bit. Signed-off-by: Bo Shen <voice.shen@atmel.com>		2015-03-18 23:36:09 +01:00
..
fm	net/fm: Enable FMAN ports if l2switch ports are connected over SGMII	2015-01-16 09:32:32 -08:00
fsl-mc	drivers/mc: Migrated MC Flibs to 0.5.2	2015-02-24 13:10:20 -08:00
phy	net: phy: micrel: add support for KSZ8895 switch in SMI mode	2015-01-30 15:55:00 -06:00
4xx_enet.c
8390.h
altera_tse.c
altera_tse.h
armada100_fec.c
armada100_fec.h
at91_emac.c
ax88180.c
ax88180.h
ax88796.c
ax88796.h
bcm-sf2-eth-gmac.c
bcm-sf2-eth-gmac.h
bcm-sf2-eth.c
bcm-sf2-eth.h
bfin_mac.c
bfin_mac.h
calxedaxgmac.c
cpsw.c
cs8900.c
cs8900.h
davinci_emac.c
davinci_emac.h
dc2114x.c
designware.c	net: Support DMA threshold mode in DWMAC driver	2015-03-05 11:17:53 -05:00
designware.h	net: configure DWMAC DMA by default AXI burst length	2015-03-05 11:17:53 -05:00
dm9000x.c
dm9000x.h
dnet.c
dnet.h
e1000.c	drivers/net/e1000.c: fix compile warning under 64bit mode	2015-01-30 09:19:16 -05:00
e1000.h
e1000_spi.c
eepro100.c
enc28j60.c
enc28j60.h
ep93xx_eth.c
ep93xx_eth.h
ethoc.c
fec_mxc.c
fec_mxc.h
fsl_mcdmafec.c
fsl_mdio.c
ftgmac100.c
ftgmac100.h
ftmac100.c
ftmac100.h
ftmac110.c
ftmac110.h
greth.c
greth.h
Kconfig
keystone_net.c	net: keystone_net: move serdes setup to initialization function	2015-02-16 12:41:41 -05:00
ks8851_mll.c
ks8851_mll.h
lan91c96.c
lan91c96.h
macb.c	Net: macb: reset GBE bit when fallback checking	2015-03-18 23:36:09 +01:00
macb.h
Makefile	Merge branch 'master' of git://git.denx.de/u-boot-fsl-qoriq	2015-02-25 18:14:18 -05:00
mcffec.c
mcfmii.c
mpc5xxx_fec.c	powerpc: mpc5xxx: remove Total5200 board support	2015-01-23 16:53:52 -05:00
mpc5xxx_fec.h
mpc512x_fec.c
mpc512x_fec.h
mvgbe.c	kirkwood: define empty CONFIG_MVGBE_PORTS by default	2015-01-25 23:56:15 +01:00
mvgbe.h
mvneta.c
natsemi.c
ne2000.c
ne2000.h
ne2000_base.c
ne2000_base.h
netconsole.c	linux/kernel.h: sync min, max, min3, max3 macros with Linux	2014-11-23 06:48:30 -05:00
ns8382x.c
pcnet.c
rtl8139.c
rtl8169.c	net: rtl8169: Add support for RTL-8168/8111g	2014-12-18 13:21:41 -07:00
sh_eth.c
sh_eth.h
smc911x.c	net: smc911x: Keep MAC programmed	2014-11-07 16:27:04 -05:00
smc911x.h
smc91111.c
smc91111.h	Add MS7206SE ethernet support	2015-01-30 15:55:00 -06:00
sunxi_emac.c
tsec.c	net: tsec: Fix NULL access in case init_phy() fails	2015-01-30 15:55:00 -06:00
tsi108_eth.c
uli526x.c	drivers/net/uli526x.c: fix syntax error	2014-11-07 16:27:07 -05:00
vsc7385.c
vsc9953.c	net/vsc9953: Add driver for Vitesse VSC9953 L2 Switch IP	2015-01-16 09:32:38 -08:00
xilinx_axi_emac.c
xilinx_emaclite.c
xilinx_ll_temac.c	net: ll_temac: Fix compilation warning because of phys_addr_t	2015-01-21 10:30:36 +01:00
xilinx_ll_temac.h
xilinx_ll_temac_fifo.c
xilinx_ll_temac_fifo.h
xilinx_ll_temac_mdio.c
xilinx_ll_temac_mdio.h
xilinx_ll_temac_sdma.c
xilinx_ll_temac_sdma.h
zynq_gem.c	net: gem: Use phys_addr_t instead of int for addresses	2015-01-21 10:30:21 +01:00