mirror of
https://git.openwrt.org/openwrt/openwrt.git
synced 2026-02-14 20:51:56 +01:00
6da2890c03
Some checks are pending
Build Kernel / Build all affected Kernels (push) Waiting to run
Add board support for the Xikestor SKS8300-12E2T2X switch. Hardware specifications: ======================== -Realtek RTL9302C SoC, 1x MIPS-34Kc, 800 MHz -512 MB DDR3 RAM -32 MB SPI-NOR Flash -12x 2.5GBASE-T Ports (RTL8224) -2x 10GBASE-T Ports (RTL8261) -2x 10G SPF+ Ports -Reset Button on the front panel -Power & SYS LED's -UART (115200 8N1) via RJ45 Flash instruction: ================== -Prepare TFTP server & connect to serial port -Connect your computer to one of the RJ45 ports -Power on and interrupt autoboot with Shift + A. -Use Shift + Q to drop from vendor CLI to U-Boot CLI. -Change U-Boot Bootcommand (needed for network functionality): > setenv bootcmd 'rtk network on; boota' > saveenv -Start network: > rtk network on -Set switch IP and TFTP server IP: > setenv ipaddr [IP-ADDRESS] > setenv serverip [IP-ADDRESS] -Load initramfs image from TFTP server: > tftpboot 0x82000000 [IMAGEFILE] -Boot with the downloaded image: > bootm 0x82000000 -Backup the stock firmware if needed -Perform sysupgrade with the sysupgrade image (in Luci or Terminal via scp & sysupgrade) Back to stock firmware: ======================= -In the Terminal enter: > fw_setenv bootcmd 'boota' -Write firmware with: > sysupgrade -F [IMAGEFILE] Signed-off-by: Michael Wagenhofer <michael@wagenhofer.de> Link: https://github.com/openwrt/openwrt/pull/21773 Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> |
||
|---|---|---|
| .. | ||
| rt-loader | ||
| common.mk | ||
| Makefile | ||
| rtl838x.mk | ||
| rtl839x.mk | ||
| rtl930x.mk | ||
| rtl930x_nand.mk | ||
| rtl931x.mk | ||
| rtl931x_nand.mk | ||