openwrt/target/linux
David Bauer 795df80917 mpc85xx: add support for Enterasys WS-AP3710i
Hardware
--------

SoC:   NXP P1020 (2x e500 @ 800MHz)
RAM:   256M DDR3 (Micron)
FLASH: 32M NOR (Spansion S29GL128S)
BTN:   1x Reset
WiFi:  1x Atheros AR9590 2.4 bgn 3x3
       2x Atheros AR9590 5.0 an 3x3
ETH:   1x Gigabit Ethernet (Atheros AR8033)
LED:   System (green/red) - Radio{0,1} (green)
       LAN (connected to PHY)
        - GE blue
        - FE green

Serial is a Cisco-compatible RJ45 next to the ethernet port.
115200-N-8 are the settings for OS and U-Boot.

Installation
------------

1. Grab the OpenWrt initramfs, rename it to 01C8A8C0.img. Place it in
   the root directory of a TFTP server and serve it at
   192.168.200.200/24.

2. Connect to the serial port and boot the AP. Stop autoboot in U-Boot
   by pressing Enter when prompted. Credentials are identical to the one
   in the APs interface. By default it is admin / new2day.

3. Set the bootcmd so the AP can boot OpenWrt by executing

   $ setenv boot_openwrt "setenv bootargs;
     cp.b 0xee000000 0x1000000 0x1000000; bootm 0x1000000"
   $ setenv bootcmd "run boot_openwrt"
   $ saveenv

   If you plan on going back to the vendor firmware - the bootcmd for it
   is stored in the boot_flash variable.

4. Load the initramfs image to RAM and boot by executing

   $ tftpboot 0x1000000 192.168.200.200:01C8A8C0.img; bootm

5. Make a backup of the "firmware" partition if you ever wish to go back
   to the vendor firmware.

6. Upload the OpenWrt sysupgrade image via SCP to the devices /tmp
   folder.

7. Flash OpenWrt using sysupgrade.

   $ sysupgrade -n /tmp/openwrt-sysupgrade.bin

Signed-off-by: David Bauer <mail@david-bauer.net>
(cherry picked from commit 16b01fb1b9)
2019-12-14 17:34:57 +01:00
..
apm821xx treewide: remove 4.19 leftovers 2019-10-08 12:45:13 +02:00
ar71xx kernel: bump 4.14 to 4.14.158 2019-12-10 09:53:30 +01:00
arc770 treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
archs38 treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
armvirt kernel: Remove CONFIG_COMPAT 2019-05-11 17:15:41 +02:00
at91 at91:renaming subtraget legacy to sam9x 2019-05-30 12:12:57 +02:00
ath25 treewide: sysupgrade: use $UPGRADE_BACKUP to check for backup 2019-09-16 05:57:08 +02:00
ath79 ath79: add support for TP-Link TL-WDR4300 v1 (IL) 2019-12-13 20:01:45 +01:00
bcm53xx bcm53xx: sysupgrade: support Luxul NAND devices 2019-10-15 20:26:22 +02:00
brcm47xx brcm47xx: add switch configuration for WNR3500L 2019-12-11 22:41:46 +01:00
brcm63xx kernel: bump 4.14 to 4.14.155 2019-11-22 16:58:21 +01:00
brcm2708 kernel: bump 4.14 to 4.14.155 2019-11-22 16:58:21 +01:00
cns3xxx kernel: bump 4.14 to 4.14.156 2019-11-29 10:00:35 +01:00
gemini kernel: bump 4.14 to 4.14.156 2019-11-29 10:00:35 +01:00
generic kernel: bump 4.14 to 4.14.158 2019-12-10 09:53:30 +01:00
imx6 treewide: remove 4.19 leftovers 2019-10-08 12:45:13 +02:00
ipq40xx ipq40xx: add support for AVM FRITZ!Repeater 1200 2019-11-22 22:32:58 +01:00
ipq806x kernel: bump 4.14 to 4.14.158 2019-12-10 09:53:30 +01:00
kirkwood kirkwood: Fix FS#505 - Can't install LEDE on Linksys EA3500 2019-10-19 14:30:05 +02:00
lantiq kernel: bump 4.14 to 4.14.156 2019-11-29 10:00:35 +01:00
layerscape kernel: bump 4.14 to 4.14.158 2019-12-10 09:53:30 +01:00
malta treewide: remove 4.19 leftovers 2019-10-08 12:45:13 +02:00
mediatek kernel: bump 4.14 to 4.14.156 2019-11-29 10:00:35 +01:00
mpc85xx mpc85xx: add support for Enterasys WS-AP3710i 2019-12-14 17:34:57 +01:00
mvebu kernel: bump 4.14 to 4.14.158 2019-12-10 09:53:30 +01:00
mxs kernel: bump 4.14 to 4.14.156 2019-11-29 10:00:35 +01:00
octeon treewide: remove 4.19 leftovers 2019-10-08 12:45:13 +02:00
octeontx kernel: Remove CONFIG_COMPAT 2019-05-11 17:15:41 +02:00
omap treewide: use new procd sysupgrade $UPGRADE_BACKUP variable 2019-09-12 13:27:29 +02:00
oxnas kernel: bump 4.14 to 4.14.158 2019-12-10 09:53:30 +01:00
pistachio kernel: bump 4.14 to 4.14.91 2019-01-07 17:09:06 +01:00
ramips ramips: allow JCG_MAXSIZE in kiB in Build/jcg-header 2019-12-13 19:54:14 +01:00
rb532 kernel: bump 4.14 to 4.14.86 2018-12-10 11:48:44 +01:00
samsung kernel: Do not set CONFIG_DEVMEM or CONFIG_DEVKMEM 2019-05-11 17:15:41 +02:00
sunxi treewide: remove 4.19 leftovers 2019-10-08 12:45:13 +02:00
tegra treewide: remove 4.19 leftovers 2019-10-08 12:45:13 +02:00
uml kernel: Deactivate CONFIG_BINFMT_MISC 2019-05-11 17:15:41 +02:00
x86 kernel: bump 4.14 to 4.14.154 2019-11-19 15:02:22 +01:00
zynq zynq: make title consistent for all devices 2019-05-17 21:41:43 +02:00
Makefile