mirror of
https://git.openwrt.org/openwrt/openwrt.git
synced 2026-02-19 10:01:15 +01:00
67e6baf05e
Netgear RBx350 are dual band 4 stream 802.11ax mesh devices from the Orbi series. The RBR350 is a router with a WAN and 3 LAN ports. The RBS350 is a satellite without WAN port, only 2 LAN ports and half the flash. The hardware is otherwise identical. They were sold in kits as RBK352, RBK353, RBK354 or RBK355, with one router and 1-4 satellites. Hardware: * SoC: Qualcomm IPQ6018 * RAM: 512MiB 1x Nanya NT5CC256M16ER-EK * Flash: 512MiB Winbond W29N04GZ or 256MiB Winbond W29N02GZ * WLAN 2.4GHz: QCN5022 2x2:2 b/g/n/ax * WLAN 5GHz: QCN5052 2x2:2 a/n/ac/ax * Ethernet: QCA8075 switch with 1 WAN and 3 LAN ports or 2 LAN ports * Serial Config: 3.3V TTL 115200-8-N-1, internal populated header * Serial Layout: 3.3V (don't connect, marked with dot) RX TX GND * LEDs: green/red power, white/red/green/blue status * Buttons: 1x Reset, 1x WPS MAC addresses: * LAN1: base address on label, stored in boarddata partition at 0x8 * LAN2: base + 1 * LAN3: base + 2 * WAN: base + 3 * 2.4GHz WLAN: base + 1 * 5GHz WLAN: base + 2 Flashing Notes: The stock firmware images are signed. Both the bootloader and the stock web interface check the signature and will fail to boot/flash. The bootloader automatically does NMRP when a gigabit LAN connection is present. The stock and factory images contain a U-Boot script that is executed when flashing using NMRP. This is used to alter and persist the U-Boot env with a boot command that works with unsigned firmware. Install OpenWrt: * Get the nmrpflash utility [0] and OpenWrt factory image * Find network interface to use: nmrpflash -L * Start nmrpflash: nmrpflash -i interface -f openwrt-...-factory.img * Connect the device LAN port closest to the power jack to the same network using gigabit * Plug the device in and wait for the bootloader to flash * Unplug and replug the device once the power LED blinks amber Revert to Stock: The boot command needs to be reverted before flashing the stock firmware, otherwise it will fail to boot and get stuck in recovery mode (red power LED flashing). * Run: fw_setenv bootcmd bootipq * Restart the device * Flash the stock firmware RBx350-Va.b.c.d.img using nmrpflash [0]: https://github.com/jclehner/nmrpflash Signed-off-by: Michael Lotz <mmlr@mlotz.ch> Link: https://github.com/openwrt/openwrt/pull/21656 Signed-off-by: Robert Marko <robimarko@gmail.com> |
||
|---|---|---|
| .. | ||
| base-files | ||
| boot | ||
| devel | ||
| firmware | ||
| kernel | ||
| libs | ||
| network | ||
| system | ||
| utils | ||
| Makefile | ||