Piotr Dymacz 57c641ba6e ar71xx: rework chipidea controller support, add QCA9531 ... Rework (again) platform support for dual-role chipidea USB controller: - include support for QCA9531 - use correct EHCI block size - drop ar933x_usb_setup_ctrl_config() function - simplify code after previous "register chipidea only in device mode" change (fa22714181) Reworked patch was tested on devices with below QCA WiSOCs (signal/GPIO name with required bootstrap state for USB bus 0 in device mode): - AR9331 (GPIO13 pull-down) - AR9342 (RGMII_TXD1/ETXD1 pull-up) - AR9344 (GPIO20 pull-up) - QCA9531 (GPIO13 pull-up) - QCA9558 (GPIO13 pull-up) The only way to select device mode for bus 0 is to change SOC bootstrap configuration which is sampled only once, at hard reset. Likely, other models, like QCA9556 or AR9341, should also support dual-role USB mode but they were not tested. Signed-off-by: Piotr Dymacz <pepe2k@gmail.com>		2018-04-06 23:11:00 +02:00
..
imagebuilder	imagebuilder: remove split patch dirs from imagebuilder archive	2018-03-07 09:59:08 +01:00
linux	ar71xx: rework chipidea controller support, add QCA9531	2018-04-06 23:11:00 +02:00
sdk	sdk: change base feed fallback to git.openwrt.org	2018-01-11 18:20:07 +01:00
toolchain	merge: etc: update remaining files	2017-12-08 19:41:18 +01:00
Config.in	config: set ARCH if powerpc64 is selected in the configuration	2017-10-24 13:24:04 +02:00
Makefile	build: make <subdir>/install opt-in, use it for target/ only	2017-02-09 13:51:35 +01:00