Tomasz Maciej Nowak 09448d8ff3 x86: add Roqos Core RC10 ethernet interfaces ... eth0 -> single NIC (i211at) eth1 -> single NIC (i211at) -> 4-port unmanaged switch (BCM53125U) Notes UART is exposed on J4 connector, pinout starting from pin marked 1: 1. GND, 2. NC?, 3. NC?, 4. RX, 5. TX, 6. NC? baud: 115200, parity: none, flow control: none The board is setup by coreboot with UEFI. To enter setup screen hold ESC key on boot. The 5-LED multicolor matrix is attached on first I2C device named "Synopsys DesignWare I2C adapter" at address 0x60. Controlling values are stored in /opt/roqos/etc/rcLED.conf of original firmware. Remember to backup the original firmware, there are no downloadable copies. Signed-off-by: Tomasz Maciej Nowak <tmn505@gmail.com>		2021-06-06 00:26:13 +02:00
..
64	x86: kernel: enable Fusion-MPT SAS driver	2021-06-06 00:26:13 +02:00
base-files	x86: add Roqos Core RC10 ethernet interfaces	2021-06-06 00:26:13 +02:00
generic	kernel: add missing config symbols, fix typos	2021-03-19 14:02:47 +00:00
geode	kernel: add missing config symbols, fix typos	2021-03-19 14:02:47 +00:00
image	x86/64: Add support for AMD SOC Ethernet controller	2021-04-17 21:56:05 +02:00
legacy	kernel: add missing config symbols, fix typos	2021-03-19 14:02:47 +00:00
patches-5.4	kernel: drop apu2 reboot patch	2021-03-24 11:51:29 +00:00
patches-5.10	kernel: drop apu2 reboot patch	2021-03-24 11:51:29 +00:00
config-5.4	kernel: Move CONFIG_USERIO to generic config	2021-03-27 14:34:22 +01:00
config-5.10	treewide: switch the timer frequency to 100 Hz	2021-04-21 10:31:10 +01:00
Makefile	x86: support kernel 5.10	2021-03-14 17:52:49 +00:00
modules.mk	x86: amd-xgbe: add missing dependencies on 5.10	2021-04-18 18:05:08 +08:00